Shrink chuck 4,5° HSK 63 - 32 - 200Application: For mounting tools with straight shanks. Note: Toolholders suitable for induction , contact and hot air shrink units. 3, 4, 5 with h4 tolerance and 6 32 with h6 tolerance For 3, 4 and 5 mm only solid carbide tool shanks must be used! All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m

In order to achieve an optimum sealing the tool must be clamped on the complete length of the ground drill of the collet

maximum = 50 mm)

For mounting milling cutters with transverse or longitudinal groove

For the transfer of a defined torque

Effective from low to high coolant pressures

Calibration of the angular position of spindles of milling-turning centres

4021 x 20Cr13

3 µm radial run-out with a 2 µm clamping nut

clamping depth l2 = max

- Calibration of the angular position of spindles of milling-turning centres

load capacity 200kg

Resolution: