ER-Collet chuck SK 40 - 2/16 - 100 | ER 25Application: For mounting straight shank tools in collets. Delivery: With balanced clamping nut All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m Tensile strength in the core of min. 800 N mm after DIN All functional surfaces fine machined

Further information on the articles included can be found under the respective article number

bei Ø 6 – Ø 32 mm = h233

The clamping screw incorporates a through hole

05mm / 1/128"

6 T-slot nuts

T-nuts 18 mmTest certificate

Soft body for later processing

Rotary holder for clamp holders with coolant supply directly to the cutting edge and for ISO clamp holders with claw clamping for optimum cooling of the cutting edge

Automatic On/Off to maximize battery life

Minimum internal diameter measurement capability of 20mm

5V Battery

Hinged mounting device for toolholders