Bondtech BMG-X2-M Extruder For MosquitoIn stock, ready to ship. Comes with the updated Shaft Gear assembly, as of 2 22 23. For 1. 75mm Filaments only The Bondtech BMG X2 is the best and lightest performing extruder on the market that combines low weight with dual high feeding capacity. Dedicated For Mosquito Hotends This extruder is available in a single version, to use Mosquito hotends. The same version is also compatible with Mosquito Magnum. SLS 3D Printed Housing in PA The housing

Fixing kit - universal

Ultem 1000 Datasheet

Documentation: How to install the Nextruder to V6 Adaptor

1x Powered by Bondtech sticker

Nozzles can be individually adjusted in height for an easy setup experience

Stock reflected on page - if you can add to cart/check out

7m extension wire + 2 pin connector

You need bossac 1

It is sized for use with the CR-10/CR-10S Pro or comparable build plates and comes standard with a high temperature 3m adhesive backing

Duet configuration files

thermistor and 0

6A on the GF45 gearmotor