Double shank ball-ends, in corrosion-resistant steel, swaged on aircraft control wire rope. Dimensions and loads1 Scope This International Standard specifies the characteristics of double shank ball ends in corrosion resistant steel swaged on aircraft control wire rope.

such as that covered by a local enterprise partnership (LEP)

there has been a lack of uniformity in the method adopted for the preparation of schematic diagrams of engineering plants generally

Annex B (normative) Presentation of results of maximum speed

regions and countries for which they are qualified

BS EN 62192:2009 Live working

Requirements for standards of workmanship for glazing have been published separately as BS 8000‑7 and

Other recommendations include environmental management and consumer-supplier relations

This European Standard is intended to cover the protection from electrostatic phenomena (ESD damage) of all electronic devices with voltage sensitivity of not lower than 100 V through their entire life

The scope of this European Standard is:

see table 5)

Introduction of the hot-spot stress method with guidance on finite element stress analysis (FEA)

targeted accuracy