End mills with indexable inserts - End mills with Morse taper shank1 Scope This part of ISO 6262 specifies the dimensions of end mills with indexable inserts and Morse taper shank according to ISO 296. The form and dimensions of the inserts are left to the discretion of the manufacturer.

BS 47-1 guides regarding the manufacturing of steel and fishplates

Note 6: The safety requirements for the transportation including loading and unloading of the components are not covered by BS EN 741

wear allowance

Auxiliary generators – Generators for supplying power for auxiliary services such as air conditioning

It specifies the method for Rockwell regular and Rockwell superficial hardness tests for scales A

PAS 1008 is an international standard on flexitank that specifies the test method and test procedure of single-use flexitank

several terms are defined

Composite tubes can be used alone or in batteries to equip trailers or skids (ISO modules) or multiple element gas containers (MEGC) for the transportation and distribution of gases

ISO/TS 24522 aims to be consistent with both the World Health Organization (WHO) Water Safety Plan approach for water supply and the WHO Sanitation Safety Planning approach for wastewater collection

Description of an extinguisher

Single-fuel and dual-fuel burners when operating only on gas

The inhibitory effect is estimated over an exposure period of usually 3 h or up to 24 h with weakly nitrifying sludge