Resistance welding. Destructive testing of welds. Specimen dimensions and procedure for mechanized peel testing resistance spot, seam and embossed projection welds1 Scope This International Standard specifies specimen dimensions and a testing procedure for mechanized peel testing of single spot, seam and embossed projection welds, in overlapping sheets, in any metallic material of thickness 0,5 mm to 3 mm, where the welds have a maximum diameter of 7t (where t is the sheet thickness in mm). For welds of diameter between 5t and 7t, the peel strength values obtained may be lower than expected when using the

geotextiles

NOTE The titles of the publications referred to in this standard are given on the inside back cover

Inclusion of hobs and ovens heated by means of RF energy

The present report does not contain sufficient detail for exact specification of requirements in a request for proposal or product security disclosure sheet

volume of the gas contained in the internal free volume of the object

It can be determined from vertical rail vibration during a train pass-by and the vertical track decay rate

Engines located in the inside of vehicles

These fluids are difficult to ignite and show little tendency to propagate flame

apparent energy

This document excludes specific qualitative and quantitative test methods for demonstrating freedom from unacceptable biological risks

Burglary attempts covered by this document are likely to avoid noise and unnecessary risk

Earthworks are commonly associated with transport infrastructure